The Myrtlewood Gallery

 

Shop Now

Cutting wire replacement instructions for your gourmet cheese

How to order replacement cutting wires for your gourmet cheese slicer.

Please remember to close this page
 after you have read or printed it.

You can receive a free replacement wire if you send in your broken wire and a self addressed stamped envelope to the address below. 

You can also purchase replacement wires for $1.00 each (with a self addressed stamped envelope).  

Please note that our replacement wires are available in two lengths.  The proper length for your cheese slicer can be determined by measuring the length of the cutting slot on your board. 

Please measure the cutting slot on your cheese slicer board to determine the wire length you need. Compare your measurement with these below, indicate whether you need a “short” or “long” wire with your order.

Short Wire. Cutting Slot = 4 ½” - 4 ¾” L
Our Myrtlewood Cheese Slicers use the Short Wire 4 5/8"

Long Wire. Cutting Slot = 5 ½” - 5 ¾”  L

Prodyne
9611 Santa Anita Ave.
Rancho Cucamonga, CA 91730
(800) 822-4776

If you need to you can order a replacement handle/wire assembly for $2.00 from Prodyne.  Please indicate the size of your cheese slicer board when ordering. 
 

 

 

Cutting wire replacement instructions for your gourmet cheese slicer.

Please remember to close this page
 after you have read or printed it.


1) Position slicer on flat surface as shown in Figure 1.
2) Loosen set screw and turn handle upward as shown by arrow in Figure 1.

3) Using narrow object (such as a nail), push wire fastening pin out.

4) While holding the base, grasp metal bar and gently slide it outward until it clears cutting slot.

5) Remove broken wire pieces.

6) Take new wire and place wire loop into cutting slot.  Slide bar back into base passing the bar through wire loop.

7) With handle in raised position as shown in Figure 2, place the other wire loop into handle cavity and reinsert fastening pin passing it through loop.  

8) Turn the handle in the direction shown in Figure 2 until it comes to rest.  Grasp handle and tighten set screw into metal bar.

9) Gently work bar either into or out of base until the wire is aligned with cutting slot.

Your Gourmet Cheese Slicer is now ready for use.

New Home

The Myrtlewood Gallery
1125 Highway 101
Reedsport OR 97467
541-271-4222
877-MYRTLE3
email
copyright protected